Herma 500 - Page 88

Opening and Editing Parameters
80 1.10 GB (2019/02/28)
Label
Make label-specific settings, e.g. stop delay, applicator speed, etc.
NOTICE: You can see an explanation for a parameter by tapping on the parameter text and then on the icon on
the display.
For parameters that require additional explanation, these explanations can be found in the corresponding sections
of the manual.
Application
Make application-specific settings, e.g. selecting the application type and defining the corresponding parameters.
NOTICE: You can see an explanation for a parameter by tapping on the parameter text and then on the icon on
the display.
For parameters that require additional explanation, these explanations can be found in the corresponding sections
of the manual.
Printer
Set parameters for the printer and printing mode.
NOTICE: You can see an explanation for a parameter by tapping on the parameter text and then on the icon on
the display.
For parameters that require additional explanation, these explanations can be found in the corresponding sections
of the manual.
Winder
Set parameters for the winder system (motorised unwinder, motorised rewinder, motorised loop module).
NOTICE: You can see an explanation for a parameter by tapping on the parameter text and then on the icon on
the display.
For parameters that require additional explanation, these explanations can be found in the corresponding sections
of the manual.