Documentation HERMA 500
1.10 GB (2019/02/28)
97
Moving Dispensing Beak
To clean the guide rollers, simply pull them out. When reinstalling them, note that the rollers will give noticeable
resistance when you are pushing them back on.
Drive/Transport Roller
The clamping plate can be completely removed. Proceed as follows:
Press the clamping plate down to open it.
Pull the pin 1 completely out. Remove the clamping plate to clean it and the transport roller.
After cleaning, replace the clamping plate and secure it with the pin 1.
Maintenance Schedule
Observe the safety instructions in the Cleaning, Maintenance, Service section!
Clean all relevant components on a regular basis according to the maintenance schedule below:
Use only cleaning material that does not attack metal, rubber, or plastic
parts.
Make sure that all machine parts that touch the products to be labelled are free from adhesive or label residues.
Remove adhesive residue with a label solvent.
Clean the label sensor/scanning unit with a soft cloth only.
Do not remove adhesive residue from guide and transport rollers with sharp-edged objects.
Do not use excessive amounts of fluids during cleaning. Do not use high-pressure or steam cleaners.
To Next Page
Loading...