Intended Use of the Machine
16 1.10 GB (2019/02/28)
working conditions at the installation location. These regulations and information must be
implemented as work instructions for operating the product.
Throughout the product’s entire service life, the operator must check whether the work
instructions created are in line with the current versions of the regulations, and adjust the work
instructions as necessary.
User 1
This user has received basic training. This user may perform activities in normal productive operation, including
handling label material and configuring the intended settings.
A password for operating the control software at operating level 1 has been assigned.
This user can view and edit the user parameters defined by the technician.
User 2
Same as for user 1. A password for operating the control software at operating level 2 has been assigned. The
user can perform mechanical format settings according to a list.
This user can view all parameters and can edit user parameters.
Technician
Same as for user 2. A password for operating the control software at operating level 3 has been assigned. This
user can perform basic mechanical adjustments.
This user can run set-up mode and define user parameters.
Specialist
A specialist has the education, technical training, knowledge of applicable regulations and experience required to
perform the work assigned to him or her such as assembly, installation, servicing and transport. A specialist can
independently identify dangers.
Trained Electrician
A trained electrician has the education, technical training, knowledge of applicable regulations and experience
required to perform work on electrical systems and independently identify potential dangers. A trained electrician
has had specific training for the working environment in which he or she works, and is familiar with the applicable
standards and regulations.
To Next Page
Loading...
