Settings – Retooling the Product
84
1.10 GB (2019/02/28)
Settings – retooling the product
Settings – Retooling the Product
Authorised Staff
User 2 – for mechanical format adjustments and loading existing formats
Technician – for creating new formats
Switch off the applicator
Accessing the machine for setting and retooling purposes could cause unexpected actions.
Turn off the machine properly before performing mechanical modifications and deactivate the compressed air
supply.
Make sure to empty the machine, i.e. remove all products from the machine, before configuring it for a different
product.
Failure to comply with these instructions could result in injuries.
Using formats is a good option for switching the HERMA 500 applicator from one product to a different one.
Formats allow you to make the necessary settings in the program quickly and easily. See the “Format” operating
menu. Mechanical settings depend on the applicator’s particular installation situation and cannot be described
here for all situations.
A typical setting is the start delay, which allows you to change the position of the label on the product. See
parameters 100 and higher in the “Product” menu.
For information on the settings (mostly mechanical) that you can make on the various units, see the following
sections below “Settings”.
Additional information about settings, functions, procedures and much more can be found in our service portal at
https://www.herma.com/machines.
To Next Page
Loading...
