Herma 500 - Replacing the Handle (Unwinder;Rewinder); Replacing the Tension Rings (Unwinder;Rewinder)

Documentation HERMA 500
1.10 GB (2019/02/28) 87
Replacing the Handle (Unwinder/Rewinder)
If, after a long period of use, the handle ceases to reliably operate the roll clamp, replace the worn handle while
observing the following:
 Turn the handle all the way to the left (maximum of five steps) to open the clamp and provide access to the
fastening screw 10.
 Loosen the screw 10 (do not remove it!), pull the handle off, place the new handle on and retighten the
screw 10.
Replacing the Tension Rings (Unwinder/Rewinder)
If the tension rings 11 become worn after a long period of use, replace the rings while observing the following
(example with overall width of 16, vertically installed applicator):
 Remove the handle as described in “Replacing the Handle (Unwinder/Rewinder)”.
 Remove parts that are now free.
 Loosen the screws that were exposed by removal of the parts (do not remove the screws!).
 Remove additional parts that are free.