Herma 500 - Installing the Applicator

Installing the Applicator
50 1.10 GB (2019/02/28)
secure it to prevent it from falling over/sliding.
Secure the transport routes (clear them and inform third parties). Transport always requires more than one
person.
Use an assembly crane/assembly aid.
If this information is not observed, people involved in transport and third parties could be seriously injured.
Observe the following when transporting the machine to its operation site using a forklift or pallet truck:
Hazards when using a forklift
Improper use of this tool could present dangers for the transporter and third parties. For this reason, observe the
following:
Guide the forks between the machine feet or the palette. Be aware of the machine’s centre of gravity.
The forks must extend so they are sticking out on the other side of the machine or the palette.
The means of transport must be approved for the weight of the machine.
Note the safety regulations for transporting and lifting heavy loads.
If this information is not observed, people involved in transport and third parties could be seriously injured.
Remove the label reel when transporting the applicator
Remove the label reel when transporting the applicator.
Installing the Applicator
If you notice any damage caused by transport while removing the machine’s packaging, notify your HERMA sales
centre immediately.
Use assembly aids
Heavy objects could tilt or fall over, and are difficult to move without appropriate aids. For this reason, observe the
following:
Use an assembly aid/assembly crane for installation. Secure the machine and its components to prevent them
from falling over.