Herma 500 - Power Failure; Customer Support

Documentation HERMA 500
1.10 GB (2019/02/28) 107
Power Failure
After a power failure, the machine may be in an undefined state. Always observe the following to ensure that
production is resumed without any problems:
1. When the power comes back on, proceed as described in the “Start-up” chapter.
2. Remove any labels that are protruding or have not been dispensed completely. Make sure that a label is
flush with the dispensing beak (normal position).
Customer Support
Central Office
Technical support
HERMA GmbH
70791 Filderstadt
Phone:
+49 (0)711 7702 551
+49 (0)711 7702 777
Fax:
+49 (0)711 7702 786
service-maschinen@herma.com
service-machines@herma.com
https://www.herma.com/machines