Herma 500 - Page 75

Documentation HERMA 500
1.10 GB (2019/02/28) 67
Settings
Make general, mostly one-time settings for the control program, e.g. the display
language.
Product
Make product-specific settings, e.g. start delay, master encoder, etc.
Label
Make label-specific settings, e.g. stop delay, applicator speed, etc.
Application
Make application-specific settings, e.g. selecting the application type, parameterising
dispensing systems, etc.
Printer
Set parameters for the printer and printing mode.
Winder
Set parameters for the winder system (motorised unwinder, motorised rewinder,
motorised loop module).
Extended settings
Make special settings for the control program, e.g. start screen parameters (see also
“Operation Using the Control Program”), parameters for CAN, OPC, fieldbus, etc.