ID2000 Series Industrial Code Reader User Manual
60
Global Manual Focus
The global manual focus requires manual focus according to the images displayed in the
live view window.
Steps
1. Go to Image Settings → Smart Tune Control → Focus Param → Focus Mode Selector,
and select Whole Area Focus as Focus Mode Selector.
2. Click in the live view window, and click it again to stop acquisition and make sure
there is an image in the window.
3. Select Focus Position according to actual demands and Focus Position Param.
4. Set Focus Step according to actual demands.
5. Click Execute in Focus Positive Execute and Focus Negative Execute to adjust focus
position.
6. (Optional) View Focus Score to know the score of the focus adjustment.
7. (Optional) Select the position parameter from Focus Position, and click Execute in Focus
Position Save to save the focus position after adjusting focus.
8. (Optional) Click Execute in Original Focus Execute to let the focus back to its original
position.
ROI Focus
The ROI focus allows you to adjust lens focus regarding the ROI area by drawing specific
area.
Note
The ROI focus is applicable to the scenario where multiple codes with different depth of
fields are existed.
Steps
1. Go to Image Settings → Smart Tune Control → Focus Param → Focus Mode Selector,
and select ROI Area Focus as Focus Mode Selector.
To Next Page
Loading...
