ID2000 Series Industrial Code Reader User Manual
76
Figure 9-30 Set and Execute Hardware Trigger Mode
Set and Execute Counter Trigger Mode
Counter specifies that the trigger source will be generated after the set number of valid
signals appears. For example, if you set the Count Number to 3, the trigger source will be
generated after 3 signals appear.
Steps
1. Click I/O Control Settings → Input → Trigger Mode.
2. Select On as Trigger Mode.
3. Select Counter 0 as Trigger Source.
4. Set Trigger Delay, Count Number, Count Source and Line Out Trigger In Polarity
according to actual demands.
Figure 9-31 Set and Execute Counter Trigger Mode
Set and Execute TCP Trigger Mode
TCP start specifies the TCP server as the source for the trigger signal. When the server
receives the specified string text, the trigger signal will be outputted.
Steps
1. Go to I/O Control Settings → Input → Trigger Mode.
To Next Page
Loading...
