4.34 Central Braking System—P3700B Model—New Brake Style
Chapter 4: Removal, Replacement, and Adjustment Procedures
Page 4 - 88 Affinity® Three Birthing Bed and Affinity® Four Birthing Bed
Service Manual (MAN272 REV 4)
17. Repeat step 2 through step 16 for the opposite side.
18. Remove the detent mechanism assembly (T) from the cross channel.
19. Slide the brake rod support bracket (O) and bushing (U) from the end of the
brake/steer pedal (A).
20. Remove the brake strips (K and V) from the base frame.
Replacement
1. To install the replacement central braking system mechanism, reverse the
removal procedure with attention to the following:
a. Make sure the brake/steer strip (straight metal strap – V) and the brake
strip (bent metal strap – K) are correctly assembled on their respective
sides.
b. Make sure the brake strips (K and V) are correctly attached to their cam
pivots.
c. Do sections “Brake and Steer Caster Adjustment” on page 4-81 and
“Brake Caster Adjustment” on page 4-82.
2. Make sure the brake and steer functions work properly.
3. Do the “Function Checks” on page 2-4.
To Next Page
Loading...
