6.4 Saving Measurement Data (As required)
103
6
Chapter 6 Measurements
Saving data during automatic measurements
Automatic measurements
1. When automatic measurements end, a list of
measurement appears as shown on the screen.
2. To save this data, enter a name and No. and
press .
When a remote command is received (and
remote status is engaged) during automatic mea-
surement, the automatic
measurement result screen does not appear.
3. Press to return to the system screen.
When saving measured data after changing the network in
the same measurement mode, the screen shown at left
may appear.
Press and change the name of the instrument.
The screen shown at left may appear when saving mea-
surement data.
If it appears, press and change the name of the
instrument.
To Next Page
Loading...
