Hioki ST5540 - Message Reference; Common Messages; Messages Specific to the Hitester

8.6 Message Reference
154
Setting of the equipment under test
8.6 Message Reference
• Any typographical mistakes in the message will result in a command error.
• Asterisk (*) indicates data applies only to ST5540.
Common Messages
Messages Explanation
Ref
page
*CLS
Clears event registers and status byte registers (p. 163)
*ESR?
Queries the event status register (p. 163)
*IDN?
Queries the equipment ID (p. 163)
*RST
Restores the default settings (factor settings) (p. 164)
*TST?
Queries the self-test and result (p. 164)
Messages Specific to the HiTESTER
Messages Explanation
Ref
page
:EQUipment
Sets the grounding class of equipment under test (p. 206)
:EQUipment?
Queries the grounding class of equipment under test (p. 206)
:EQUipment
:IDENtity
Sets the equipment name/control number of equipment under
test
(p. 207)
:EQUipment
:IDENtity?
Queries the equipment name/control number of equipment
under test
(p. 207)
*
:EQUipment
:TYPE
Sets the applied part of equipment under test
(Network B1, B2 only)
(p. 207)
*
:EQUipment
:TYPE?
Queries the applied part of equipment under test
(Network B1, B2 only)
(p. 207)