Hioki ST5540 - To Transfer All Saved Data to a Computer

8.8 To Transfer All Saved Data to a Computer
243
8
Chapter 8 Controlling the Instrument From a Computer
1. Transmit :MEMory:NUMBer? to read the number of models (total number of
data units).
2. Transmit :MEMory:READ:IDENtity? <data unit number> to read the
equipment name and control number of the specified data unit.
1. Transmit
:MEMory:READ:MEASure? <data unit number>, <measure-
ment mode> to read the saved data of the designated measurement mode for
the specified data unit.
If only "0" is received as data, there is no saved data for that mode.
2. Step (1) above is repeated as many times as the number of specified mea-
surement modes.
3. When there are two or more models (total number of data units), the process in
step
2. above is repeated.
8.8 To Transfer All Saved Data to a Com-
puter
Is data saved for all
data units read?
Number of models
(total number of data units)
= 0?
Reads the equipment
name/control number.
Is data saved for all
measurement
modes read?
Reads the saved data of
the measurement mode.
End
YES
YES
YES
NO
NO
NO
:MEMory:NUMBer?
:MEMory:READ:IDENtity?
:MEMory:READ:MEASure?
<data unit number> ,
<data unit number>
<measurement mode>
Reads the number of models
(total number of data units).