Hioki ST5540 - Saving Measurement Conditions (Panel Save Function) (as Required)

6.5 Saving Measurement Conditions (Panel Save Function) (as required)
106
Up to 30 panels of measurement condition data can be saved in internal memory.
Saved measurement conditions can be read at a later date.
See"7.2 Panel Load(Loading Saved Measurement Conditions)" (p. 120)
The following conditions are saved in a panel.
Saved panels can be initialized.
See"7.3 Initializing the Instrument" (p. 121)
6.5 Saving Measurement Conditions
(Panel Save Function) (as required)
•Network
• Measurement mode
• Filter ON/OFF
• Grounding class
• Registered equipment name/control number
• Allowable value (normal condition, fault condition, upper limit value, lower limit value)
• Manual/Auto measurement
• Measurement range
• Target current
• Equipment status (power supply polarity, fault mode, SW status, Other test condition (Other applied volt-
ages), Special test condition (Specific applied voltage), combination of items for automatic measurement)
• Measuring time/measurement delay time for automatic measurement