Hioki ST5540 - Saving Measurement Data (as Required)

6.4 Saving Measurement Data (As required)
102
Use the steps below to save measurement data (maximum values) in internal memory.
When measurements end, saved data can be confirmed in the save data reference screen.
See "Checking Saved Measurement Data" (p. 104)
6.4 Saving Measurement Data (As required)
Manual measurements
1. On the measurement screen, press to dis-
play the screen for selecting the data to be saved.
2. Save measurement data.
Press to save the data.
Press to return to the measurement screen
without saving the data.
3. If the data is already saved, a message appears
and asks whether to overwrite the existing data.
Press to overwrite the existing data.
To switch the memory used to save data, register
the data under a different equipment name and
control number.
Press to return to the measurement screen
without saving the data.
Each registered equipment name/control number
represents one unit. The instrument can save up to
100 units. Each unit can be saved with the results
of all measurement items corresponding to the net-
work and grounding class.
If the 100 unit memory capacity is exceeded, the
screen shown on the left appears.
Up to 2,000 maximum values can be saved. If this
limit is exceeded, the screen displays "No more
memory."
See "Deleting Saved Data" (p. 105)
Press . A screen appears to confirm whether to save
the measurement data.
Press
to save measurement conditions.
See "6.5 Saving Measurement Conditions (Panel Save Func-
tion) (as required)" (p. 106)
Press to return to the measurement screen.
To change the equipment name or control number, press
or and enter the new name or number.
See "Registering an Equipment Name/Control Number" (p. 50)
2
3