For setting the unit of measurement data and setting
the instrument for use as a voltmeter.
See (p. 117)
For viewing saved measurement data.
See (p. 104)
For loading saved measurement condition data.
See (p. 120)
For system initialization.
See (p. 121)
Switches the display language between Japanese
and English.
See (p. 123)
For checking power line connection for measure-
ment, input voltage measurement, and current con-
sumption and power consumption of equipment
under test.
See (p. 42)
Enables the user to check whether the network relay
works normally.
See (p. 41)
Enables the user to check whether or not the fuse is
blown.
See (p. 123)
For main instrument operation check.
See (p. 124)
1. Mode Setting
2. Save Data
3. Panel Load
4. Initialize
5. Language
6. Connect/VA Check
7. Relay Check
8. Fuse Check
9. Self Test
Enables the user to set power on polarity switching.
See (p. 126)
Enables the user to set the frequency range.
(0.1 Hz to 1M Hz, 15 Hz to 1M Hz)
See (p. 43)
Sets the status of the instrument after completing
automatic measurements.
See
Enables the user to set a lower limit value for all
measurements.
See (p. 130)
Allows the user to set the unit to be displayed.
See
For setting date and time.
See (p. 132)
For selecting interface and setting communication
condition.
See (p. 133)
For ON/OFF setting of the beep sound and warning
buzzer for key entry.
See (p. 135)
For setting backlight constant ON/auto OFF.
See (p. 136)
Go between pages.
Returns to the initial screen.
10. Polarity Change
11. Frequency Range
12. Auto Measure
13. Allowable (Lo)
14. Indication Unit
15. Date/Time
16. Interface
17. Beep
18. Back Light
System screen2System screen1
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
To Next Page
Loading...
