Hioki ST5540 - Page 170

8.7 Command Message Description
164
Restores the default settings (factor settings)
Syntax
Command
*RST
Function
Command
Initializes the instrument settings.
The initial screen appears after initialization is completed.
Same as specifying
ALL with HiTESTER initialization command :SYS-
Tem:RESet
Example
Command
*RST
Initializes the instrument settings.
Error
Any data following a command results in a command error.
Note
The communication conditions are not initialized.
Queries the self-test and result
Syntax
Query
Response
*TST?
<numerical value>
<numerical value> = 0, 2 (NR1)
0: No error
2: RAM error
Function
Query Conducts a self-test of main instrument and returns the result as a numeric
value of 0 or 2.
Example
Query
Response
*TST?
2
A RAM error has occurred.
Error
If the response message exceeds the output queue size, a query error occurs.
Note
A self-test initiated by a communications command is a RAM test only. The key
test, LCD test, (zzz) test, and LED test on the self-test screen are not con-
ducted by a communications command.