Hioki ST5540 - Page 125

7.1 Setting the Mode (To use the instrument as a voltmeter)
119
89
7
Chapter 7 Instrument System Settings
When mode is selected
1. Connect the instrument and the equipment under test.
See "3.3 Connecting equipment under test to the instrument" (p. 36)
2. Selecting protective conductor ammeter in the mode setting screen opens the protective
conductor current measurement screen.
3. Set the circuit breaker to On.
The measurement screen starts measuring protective conductor current.
Measurement conditions can be changed during measurement.
4. Press to return to the mode setting screen.
Sets DC current.
Sets AC current.
Sets AC + DC current.
Sets AC current peak.
Sets the 50 mA range.
Sets the 10 mA range.
4
1
3