10.12 General Specifications
267
8
9
Chapter 10 Specifications
10
Applicable Standards EMC
EN 61326 Electric equipment for measurement, control and laboratory use -
EMC requirements
Part 1: General requirements
EN 61000-3-2 High-frequency current
EN 61000-3-3 Voltage fluctuations
Safety
EN61010 Contamination grade 2
T1, T2 terminals: Measurement category II
(expected transient over voltage 2.5 kV)
T3 terminal (expected transient over voltage 1.5 kV)
*
Effect of conducted
disturbances, induced
by radio frequency
fields
Less than 3% at 3 V (typical value for 500 A)
Accessories L2200 Test Lead 1 set (1 red, 1 black)
Test Lead (red)* 1
9195 Enclosure Probe 1
Power cord 3
AC IN : For powering instrument 1
LINE IN* : one 15 A power cord with plug, one 20 A power cord without plug2
(Select a cord that suits the power supply of equipment under test)
Varies with the target market for which the instrument was
manufactured.
(one 10 A power cord with plug, one 20 A power cord without plug)
(Current value printed on connector) 2
Spare fuses for measurement line 250 V F50mAL 1
Instruction manual 1
CD-ROM 1
Options 9637 RS-232C CABLE (9-pin to 9-pin., crossing cable)
9638 RS-232C CABLE (9-pin to 25-pin., crossing cable)
9442 PRINTER
9443-01 AC ADAPTER (for printer / Japan )
9443-02 AC ADAPTER (for printer / EU)
9444 CONNECTION CABLE (for printer, 9-pin to 9-pin, straight cable)
1196 RECORDING PAPER (for printer, 112 mm x 25 m, 10 rolls)
*
only ST5540
To Next Page
Loading...
