Hioki Super megohm SM7110 - Page 81

75
Setting Resistivity Calculation (Resistivity Measurement Function)
If [EDIT] is selected
Numerical value can also be changed with the numeric keypad. See “Methods for changing
numerical values” (p. 28).
1
Set the diameter of the main electrode (D1).
0.0 mm to 100.0 mm (Can be set in increments of 0.1 mm, default setting: 50.0 mm)
Settle
Cancel
Move to the next
digit (left or right)
Change the
numerical value
(up or down)
2
Set the inner diameter of the counter electrode (D2).
0.0 mm to 100.0 mm (Can be set in increments of 0.1 mm, default setting: 70.0 mm)
Settle
Cancel
Move to the next
digit (left or right)
Change the
numerical value
(up or down)
3
Set the thickness (t) of the object to be measured.
0.0 mm to 100.0 mm (Can be set in increments of 0.1 mm, default setting: 0.1 mm)
Settle
Cancel
Move to the next
digit (left or right)
Change the
numerical value
(up or down)
4
Applied Measurement