E1 Series Servo Drive User Manual Software Settings And Trial Operation
HIWIN MIKROSYSTEM CORP. 7-3
7.2 Software installation and connection
Figure7.2.1
Download the setup file of Thunder from
the
official website of HIWIN
Mikrosystem. Correctly install Thunder
into PC.
Connect the servo drive and PC by mini
USB cable. Then open Thunder.exe.
Step 3:
Select the servo drive and click on
Connect button.
The figure on the right is the main screen
of Thunder. Control mode, servo drive
information, firmware version and motor
type are shown in the left column.
To Next Page
Loading...
