Hiwin E1 Series User Manual

E1 Series Servo Drive User Manual Basic Function Settings Before Operation
HIWIN MIKROSYSTEM CORP. 6-5
MD09UE01-1910
6.1.3 Parameter setting
Parameters can be set via the parameter list in Thunder or the servo drive panel.
 Set parameters via the parameter list in Thunder
Figure6.1.3.1 The Parameter list in Thunder
 Set parameters via servo drive panel
Refer to section 14.2.
6.1.4 Parameter initialization
Parameters can be set to factory default by parameter initialization function or servo drive panel.
 Before executing parameter initialization function
(1) Must be in servo off state.
(2) If you would like to use the original parameter settings later, ensure you have made a backup.
 After parameter initialization function is executed, all the parameter settings will be
cleared. Then the servo drive will be automatically turned off and turned on again.
And the parameters are set to factory default.

Hiwin E1 Series Specifications

General

Brand	Hiwin
Model	E1 Series
Category	Servo Drives
Language	English