HIWIN MIKROSYSTEM CORP. 7-1
7. Software settings and trial operation
00 00
7. Software settings and trial operation ····························································································· 7-1
7.1 Trial operation procedure ······································································································ 7-2
7.2 Software installation and connection ························································································ 7-3
7.3 Configuration Wizard ············································································································ 7-4
7.4 Inspection before trial operation ······························································································ 7-5
7.4.1 Inspection procedure for servo motor (AC) ········································································· 7-5
7.4.2 Inspection procedure for customized servo motor (AC)/linear motor (LM)/direct drive motor (DM) ··· 7-5
7.5 Detection for electrical angle ·································································································· 7-6
7.5.1 SW method 1 ··············································································································· 7-7
7.5.2 Digital Hall ··················································································································· 7-8
7.6 Trial operation with Thunder ·································································································· 7-9
7.6.1 JOG ··························································································································· 7-9
7.6.2 Point-to-point (P2P) motion ··························································································· 7-10
To Next Page
Loading...
