Hiwin E1 Series - Control Signals (CN6)

E1 Series Servo Drive User Manual Electrical Planning
5-26 HIWIN MIKROSYSTEM CORP.
MD09UE01-1910
 When brake is connected to relay
Figure5.4.4.1
5.5 Control signals (CN6)
5.5.1 Control signal connector
The pin definition of control signal connector is provided in table 5.5.1.1. Perform wiring according to the
control mode and I/O signals in use.
Note:
For information of control signal cable, please refer to table 16.1.5.1 in section 16.1.5.
 E1 series servo drive (CN6)-Standard
Figure5.5.1.1 Pin definition of CN6-Standard
1
.
.
.
.
.
.
.
.
.
25
26
.
.
.
.
.
.
.
.
.
50