Hiwin E1 Series - Parameter Initialization (Ft005)

E1 Series Servo Drive User Manual Panel Operation
14-18 HIWIN MIKROSYSTEM CORP.
MD09UE01-1910
Step Display Key Operation
6
Press DATA/SHIFT key for one second to
display Ft003.
14.4.5 Parameter initialization (Ft005)
Table14.4.5.1
Step Display Key Operation
1
Press F key to go to auxiliary function mode
(Ft). Press UP or DOWN
key to display
Ft005.
2
Press DATA/SHIFT
key for one second to
show the display on the left.
3
(Blinking)
Press F
key to perform parameter
initialization. After parameter initialization
completes, the display on the left shows.
4
－
After parameter initialization completes, the
display on the panel automatically returns to
the display on the left.
5
To let the setting become effective, after phase initialization completes, save parameter to servo drive Flash
by Ft001.