E1 Series Servo Drive User Manual Troubleshooting And Maintenance
HIWIN MIKROSYSTEM CORP. 13-3
13.1.3 Deleting error log
The error log will not be deleted after alarm reset or the main circuit power is cut off. To clear the error log,
please follow the procedure below. Tools used to delete error log are described as below.
(1) Servo drive panel
Refer to section 14.4.6 Deleting error log (Ft006).
(2) Thunder
Click on Tools on the menu bar to open ErrorLog window. Click on Clear histories button indicated
in figure 13.1.3.1.
Figure13.1.3.1
To Next Page
Loading...
