INTRODUCTION
1.16
ThinPrep 2000 Processor Operator’s Manual
INTERNAL QUALITY CONTROL
Power On Self Test (POST)
When the ThinPrep 2000 processor is powered on (refer to page 2.9), the system goes through a self-
diagnostic test. The electrical, mechanical and software/communications subsystems are tested to
confirm that each performs properly. The operator is alerted to malfunctions by a message on the
LCD display and audible beeps.
THINPREP 2000 HAZARDS
The ThinPrep 2000 system is intended to be operated in the manner specified in this manual. Be sure
to review and understand the information listed below in order to avoid harm to operators and/or
damage to the instrument.
If this equipment is used in a manner not specified by the manufacturer, then the protection provided
by the equipment may be impaired.
Warnings, Cautions and Notes
The terms
WARNING
,
CAUTION
and
Note
have specific meanings in this manual.
A
WARNING
advises against certain actions or situations that could result in personal injury or
death.
A
CAUTION
advises against actions or situations that could damage equipment, produce
inaccurate data or invalidate a procedure, although personal injury is unlikely.
A
Note
provides useful information within the context of the instructions being provided.
Symbols Used on the Instrument
The following symbols are used on this instrument:
To Next Page
Loading...
