IS barriers or via conduit when installed per Installation Drawing 40-6062 (EC 350) / 40-6155 (ERX
350).
l
Battery pack 40-6197 used to power the CloudLink 5G Modem shall not be replaced in Hazardous
areas.
Installation and commission EC350 in hazardous areas:
EC350 must be installed and commissioned only by specially trained and qualified staff. The device is
designed in accordance with the IP 65 degree of protection as per EN 60529. The installation of the
intrinsically safe circuits must comply with the applicable local laws or regulations. Operate EC350 only if
the instrument is completely intact.
1.2.1.2 Service, maintenance, and troubleshooting EC350
The service, maintenance and troubleshooting of EC350 device operating in hazardous areas must be
performed only by specially trained and qualified staff.
Replacement of EC350 battery pack
To maintain acceptability of use in hazardous locations, you must use replacement batteries supplied by
Honeywell. For further information about changing the EC350 battery pack, refer to the section,
“Replacing the Battery Pack”.
1.2.1.3 FCC: Part 15 B Class-A Digital device
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
l
This device may not cause harmful interference, and;
l
This device must accept any interference received, including interference that may cause undesired
operation.
1 About EC350
1.2 Safety instructions
Honeywell 2024
8
To Next Page
Loading...
Need help?
General
