and Scheduled Call In or Scheduled Call In Only.
7.2.1.3 Alarm Call In
If alarm call in is configured and enabled, a call will be initiated whenever a new alarm occurs or, if in RBX
mode, an alarm condition clears. This requires a phone number in item 493 ( and optionally in 785 ) and
item 333 must be set to either Alarm and Scheduled Call In or Alarm Call In Only.
7.2.1.4 Force schedule Call
If the Force Schedule Call (i1693) is configured and enabled, and the device does not attempt Schedule
Call In (i1693) in configured time for various reasons, the Force Schedule Call initiates Call In with the
server.
Note: By default, the Force Schedule Call is configured for 36 hours (2160 minutes).
Note: If the user wants to disable the Force Schedule Call feature, set the item i1693 value to 0.
7.2.1.5 Management of Multiple Phone Numbers
If multiple phone numbers are configured, item 1230 determines ( along with the retry strategy ) when
and if the second number is called. The setting will affect the behavior of scheduled and alarm calls
identically.
Call In Sequence = BOTH:
When a call is triggered, the EC350 will dial the first number first. Regardless of whether that call
succeeds or fails, the second number will also be called. The BOTH algorithm ensures that both
hosts will (eventually) receive notification. If a call to a host fails, it will be retried as many times as
necessary until the call succeeds. The two numbers are independent ā whatever happens on phone
number 1 will not affect phone number 2 and vice-versa.
Call In Sequence = PRIORITY:
This algorithm ensures that someone will (eventually) receive notification, and it will be whoever
succeeds first. As soon as either one succeeds the process is complete. Some possible sequences
are:
1 S. Done.
1 F, 2 S. Done.
1 F, 2 F, 1 S. Done.
1 F, 2 F, 1 F, 2 S. Done.
7 Remote Communications
7.2 īCall in and call out
Honeywell 2024
220
To Next Page
Loading...
Need help?
General
