Click on SAVE button.
Once the new report unit is available in dropdown, now user can associate this report unit to any
inputs existing in the database. To validate this UNIT is available for calculation; verify it in DATA
VIEWER application, shown below:
Note: The Operator and Factors given for the REPORT or FIELD UNITS should be used correctly
in DATA VIEWER. In the below screenshot user can see the SCM report unit contains the
Operator1=* and Factor1=10. It means the multiplication by 10 should be done in data viewer, if
user displays the data in data-viewer application for report unit selected as SCM .
6 User Access
6.5 îWorking with PowerSpring
Honeywell 2024
206
To Next Page
Loading...
