Honeywell EC350 - Page 217

alarms thathe wants to display in PowerSpring Alarm/System Monitor application. As shown below
user has to EDIT the existing alarm.
Use this tab to edit the Remote Unit Hardware Alarms' information. However, there are certain
hardware alarms that are "non-maskable;" that is, the hardware alarms are always active and you
are only permitted to customize the name (user description). When you select one of these
hardware alarm types, (from the Hardware alarm list), the Immediate alarm notification check box
and Nuisance limit box, (under Alarm Specification), appear dimmed and are unavailable for
modification.
Note: Alert Mode: Select the Notify Immediately check box to enable the Remote Unit to call
immediately when the selected hardware alarm is detected. Another critical purpose of CLEAR
ALARMS checkbox is that, it will clear the hardware alarms in the device (i.e. EC350) once the
call is successful in PowerSpring.
Nuisance Limit: Specifies the number of times that the selected alarm can occur prior to being
disabled. Type a number and if the "Nuisance limit" is met, the alarm notifies the selected Remote
Unit to repeat the alarm. Properties: You can save, log, or select to alert an alarm.
Save - Saves the selected Hardware alarm occurrence to the database (Alarm Data File).
6 User Access
6.5 Working with PowerSpring
Honeywell 2024
208