Configuration
86 UDC2500 Universal Digital Controller Product Manual 4/07
The content of the Emails sent by this controller contains the Alarm that triggered the
Email, its settings and the current value (if applicable) of the monitored variable. For
example, the content of an Email triggered by Alarm 1 Setpoint 1 that is configured to
monitor Input 1 would look something like this:
Name: Alarm 1 SP1, Type: INPUT1, Event: HIGH/END, Value = 500.00,
Actual = 712.69
The content of an Email triggered by Alarm 2 Setpoint 1 that is configured to monitor
Digital Input 1 would look something like this:
Name: Alarm 2 SP1, Type: DIG IN1, Event: HIGH/END, Value = 0.00,
Actual = 0.00
ATTENTION
Email will always be time-stamped with the date that the Ethernet Software in the instrument
was last modified.
If the SMTP address on your network is changed, such as can happen when a server is
replaced, then you must reconfigure the Email SMTP IP address in this instrument to match the
new IP address.
To Next Page
Loading...
