Configuration
4/07 UDC2500 Universal Digital Controller Product Manual 85
WARNING
After you change the IP Address, you will no longer be able to communicate with the instrument
via Ethernet until you change the P.I.E. Tool’s IP Address setting in the PC COMM SETUP
section to match the setting that is now in your controller. See Section
4.23 – Configuring your
Ethernet Connection for more information.
Email Configuration Screen
This controller may be configured to support sending an Email when an alarm occurs.
Emails are sent only when the selected alarm transitions from the OFF to the ON state.
Figure 3-2 Email Configuration Screen
This controller cannot receive Emails, so it is suggested that you configure the From
Email: window with a non-Email style address that will make it easy for you to
determine which controller sent the Email. For Email technical reasons, the entry in the
From Email: window cannot have spaces. See Figure 3-2.
If you do not know your SMTP IP Address for outgoing Email, then contact your
Information Technologies (IT) representative. If your PC is on the same LAN that will be
used by the controller and which also connects to the Email server, then the SMTP IP
Address may generally be found by opening a DOS shell and typing:
ping smtp.[your domain name and extension], i.e., ping smtp.your_isp.com
To Next Page
Loading...
Need help?
General
