Honeywell UDC2500 User Manual

Output Calibration
4/07 UDC2500 Universal Digital Controller Product Manual 151
6 Output Calibration
6.1 Overview
Introduction
This section describes the field calibration procedures for the following types of outputs:
• Current Output
• Auxiliary Output
What's in this section?
The following topics are covered in this section.
TOPIC See Page
6.1 Overview 151
6.2 Current Output Calibration 152
6.3 Auxiliary Output Calibration 154
6.4 Restore Output Factory Calibration 156
WARNING—SHOCK HAZARD
OUTPUT CALIBRATION MAY REQUIRE ACCESS TO HAZARDOUS LIVE CIRCUITS, AND
SHOULD ONLY BE PERFORMED BY QUALIFIED SERVICE PERSONNEL. MORE THAN
ONE SWITCH MAY BE REQUIRED TO DE-ENERGIZE UNIT BEFORE CALIBRATION.

Honeywell UDC2500 Specifications

General

Type	Universal Digital Controller
Alarm Relays	Up to 2 alarm relays
Communication	RS485 Modbus RTU
Mounting	Panel Mount
Display	Dual 4-digit LED
Input Types	Thermocouple, RTD, mA, V
Control Modes	On/Off, PID
Output Types	Relay, mA, V
Power Supply	100-240 VAC, 24V DC
Dimensions	96x96x132 mm