Honeywell UDC2500 User Manual

Introduction
xi UDC2500 Universal Digital Controller Product Manual 4/07
Table 10-7 Computer Setpoint Selection ________________________________________________ 194
Table 10-8 Computer Setpoint Associated Parameters _____________________________________ 195
Table 10-9 Set-up Group – Tuning ____________________________________________________ 196
Table 10-10 Set-up Group – Setpoint Ramp/Rate _________________________________________ 198
Table 10-11 Set-up Group – Accutune__________________________________________________ 201
Table 10-12 Set-up Group – Algorithm _________________________________________________ 202
Table 10-13 Set-up Group – Output____________________________________________________ 203
Table 10-14 Set-up Group – Input 1____________________________________________________ 204
Table 10-15 Set-up Group – Input 2____________________________________________________ 207
Table 10-16 Set-up Group – Control ___________________________________________________ 209
Table 10-17 Set-up Group – Options ___________________________________________________ 211
Table 10-18 Set-up Group – Communications____________________________________________ 213
Table 10-19 Set-up Group – Alarms ___________________________________________________ 214
Table 10-20 Set-up Group – Display ___________________________________________________ 217
Table 10-21 Modbus RTU Data Layer Status Exception Codes ______________________________ 219

Honeywell UDC2500 Specifications

General

Type	Universal Digital Controller
Alarm Relays	Up to 2 alarm relays
Communication	RS485 Modbus RTU
Mounting	Panel Mount
Display	Dual 4-digit LED
Input Types	Thermocouple, RTD, mA, V
Control Modes	On/Off, PID
Output Types	Relay, mA, V
Power Supply	100-240 VAC, 24V DC
Dimensions	96x96x132 mm