402
Ste
Command
Remarks
2. Enter routing policy node view.
route-policy route-policy-name
{ deny | permit } node
node-number
N/A
3. Set the AS_PATH attribute for
BGP routes.
apply as-path
as-number&<1-32> [ replace ]
By default, no AS_PATH attribute is
set for BGP routes.
4. Delete the specified
COMMUNITY attribute for
BGP routes.
apply comm-list
{ comm-list-number |
comm-list-name } delete
By default, no COMMUNITY
attribute is deleted for BGP routes.
5. Set the specified COMMUNITY
attribute for BGP routes.
apply community { none |
additive |
{ community-number&<1-32> |
aa:nn&<1-32> | internet |
no-advertise | no-export |
no-export-subconfed } *
[ additive ] }
By default, no community attribute is
set for BGP routes.
6. Set a cost for routes.
apply cost [ + | - ] value By default, no cost is set for routes.
7. Set a cost type for routes.
apply cost-type { external |
internal | type-1 | type-2 }
By default, no cost type is set for
routes.
8. Set the extended community
attribute for BGP routes.
apply extcommunity { rt
route-target }&<1-32>
[ additive ]
By default, no extended community
attribute is set for BGP routes.
9. Set the next hop for routes.
• Set the next hop for IPv4
routes:
apply ip-address next-hop
ip-address [ public |
vpn-instance
vpn-instance-name ]
• Set the next hop for IPv6
routes:
apply ipv6 next-hop
ipv6-address
By default, no next hop is set for
IPv4/IPv6 routes.
The apply ip-address next-hop and
apply ipv6 next-hop commands do
not apply to redistributed IPv4 and
IPv6 routes.
10. Redistribute routes to a
specified ISIS level.
apply isis { level-1 | level-1-2 |
level-2 }
By default, routes are not
redistributed into a specified IS-IS
level.
11. Set a local preference for BGP
routes.
apply local-preference
preference
By default, no local preference is set
for BGP routes.
12. Set MPLS labels.
apply mpls-label By default, no MPLS label is set.
13. Set the ORIGIN attribute for
BGP routes.
apply origin { egp as-number |
igp | incomplete }
By default, no ORIGIN attribute is set
for BGP routes.
14. Set a preference.
apply preference preference By default, no preference is set.
15. Set a preferred value for BGP
routes.
apply preferred-value
preferred-value
By default, no preferred value is set
for BGP routes.
16. Set a prefix priority.
apply prefix-priority { critical |
high | medium }
By default, no prefix priority is set,
which means the prefix priority is
low.
To Next Page
Loading...
