To Next Page

To Previous Page

Web and MAC Authentication

Configuring MAC Authentication on the Switch

Syntax: [no] aaa port-access mac-based < port-list >

Enables MAC-based authentication on the specified

ports. Use the no form of the command to disable MAC-

based authentication on the specified ports.

Syntax: aaa port-access mac-based [e] < port-list > [addr-limit <1-32>]

Specifies the maximum number of authenticated

MACs to allow on the port. (Default: 1)

Note: On switches where MAC Auth and 802.1X can

operate concurrently, this limit includes the total

number of clients authenticated through both methods.

Syntax: [no] aaa port-access mac-based [e] < port-list > [addr-moves]

Allows client moves between the specified ports under

MAC Auth control. When enabled, the switch allows

addresses to move without requiring a re-authentica-

tion. When disabled, the switch does not allow moves

and when one does occur, the user will be forced to re-

authenticate. At least two ports (from port(s) and to

port(s)) must be specified. Use the no form of the

command to disable MAC address moves between ports

under MAC Auth control. (Default: disabled – no moves

allowed)

Syntax: aaa port-access mac-based [e] < port-list > [auth-vid <vid>]

no aaa port-access mac-based [e] < port-list > [auth-vid]

Specifies the VLAN to use for an authorized client. The

Radius server can override the value (accept-response

includes a vid). If auth-vid is 0, no VLAN changes occur

unless the RADIUS server supplies one. Use the no form

of the command to set the auth-vid to 0.(Default: 0).

3-34

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General