To Next Page

To Previous Page

Configuring RADIUS Server Support for Switch Services

RADIUS Server Configuration for Per-Port CoS (802.1p Priority) and Rate-Limiting

RADIUS Server Configuration for

Per-Port CoS (802.1p Priority) and Rate-

Limiting

This section provides general guidelines for configuring a RADIUS server to

dynamically apply CoS (Class of Service) and Rate-Limiting for inbound traffic

on ports supporting authenticated clients. To configure support for these

services on a specific RADIUS server application, refer to the documentation

provided with the application. (If multiple clients are authenticated on a port

where inbound CoS and Rate-Limiting values have been imposed by a RADIUS

server, the CoS and Rate-Limiting applied to all clients on the port are those

that are assigned by RADIUS for the most recently authenticated client.

Service Control Method and Operating Notes:

802.1p (CoS) Priority

Assignments on

Inbound Traffic

This feature assigns a

RADIUS-specified

802.1p priority to all

inbound packets

received on a port

supporting an

authenticated client.

Vendor-Specific Attribute configured in the RADIUS server.

ProCurve (HP) vendor-specific ID:11

VSA: 40 (string = HP)

Setting: HP-COS = xxxxxxxx where:

x = desired 802.1p priority

Note: This is typically an eight-octet field. Enter the same x-value

in all eight octets

Requires a port-access (802.1X Web Auth, or MAC Auth)

authentication method configured on the client’s port on the ProCurve

switch.

For more on 802.1p priority levels, refer to the section titled

“Overview” in the “Quality of Service (QoS)” chapter of the Advanced

Traffic Management Guide for your switch.

6-4

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General