To Next Page

To Previous Page

Configuring Secure Socket Layer (SSL)

Configuring the Switch for SSL Operation

Using the CLI Interface to Enable SSL

Syntax: [no] web-management ssl

Enables or disables SSL on the switch.

[port < 1-65535 | default:443 >]

The TCP port number for SSL connections (default:

443). Important: See “Note on Port Number” on page

8-20.

show config

Shows status of the SSL server. When enabled web-

management ssl will be present in the config list.

To enable SSL on the switch

1. Generate a Host certificate if you have not already done so. (Refer to “2.

Generating the Switch’s Server Host Certificate” on page 8-8.)

2. Execute the web-management ssl command.

To disable SSL on the switch, do either of the following:

■ Execute no web-management ssl.

■ Zeroize the switch’s host certificate or certificate key. (page 8-9).

Using the Web Browser Interface to Enable SSL

To enable SSL on the switch

i. Proceed to the Security tab then the SSL button

ii. Select SSL Enable to on and enter the TCP port you desire to

connect on.

iii. Click on the

[Apply Changes] button to enable SSL on the port.

To disable SSL on the switch, do either of the following:

i. Proceed to the Security tab then the SSL button

ii. Select SSL Enable to off .

iii. Click on the [Apply Changes] button to enable SSL on the port.

8-19

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General