HP PROCURVE 2910AL User Manual

Configuring RADIUS Server Support for Switch Services
Configuring and Using RADIUS-Assigned Access Control Lists
ProCurve(config)# show port-access authenticator 2-3
Port Access Authenticator Status
Port-access authenticator activated [No] : No
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
Auth Unauth Untagged Tagged Kbps In RADIUS Cntrl
Port Clients Clients VLAN VLANs Port COS Limit ACL Dir
---- -------- -------- -------- ------ --------- ----------- ------ -----
2 1 0 1 7 90 No In
3 1 0 1 5 50 Yes In
Figure 6-8. Example of Output Showing Current RADIUS-Applied Features
ICMP Type Numbers and Keywords
Below are the possible optional ICMP type specifiers for the icmp-type param-
eter.
Table 6-5. ICMP Type Numbers and Keywords
IPv4 ICMP
#
Keyword
0
3
4
5
8
9
10
11
12
13
14
15
16
17
18
echo reply
destination unreachable
source quench
redirect
echo request
router advertisement
router solicitation
time-to-live exceeded
IP header bad
timestamp request
timestamp reply
information request
information reply
address mask request
address mask reply
6-28

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)