To Next Page

To Previous Page

RADIUS Authentication and Accounting

Changing RADIUS-Server Access Order

Figure 5-19. Example of RADIUS Accounting Information for a Specific Server

Figure 5-20. Example Listing of Active RADIUS Accounting Sessions on the Switch

Changing RADIUS-Server Access Order

The switch tries to access RADIUS servers according to the order in which

their IP addresses are listed by the show radius command. Also, when you add

a new server IP address, it is placed in the highest empty position in the list.

Adding or deleting a RADIUS server IP address leaves an empty position, but

does not change the position of any other server addresses in the list. For

example if you initially configure three server addresses, they are listed in the

order in which you entered them. However, if you subsequently remove the

second server address in the list and add a new server address, the new

address will be placed second in the list.

Thus, to move a server address up in the list, you must delete it from the list,

ensure that the position to which you want to move it is vacant, and then re-

enter it. For example, suppose you have already configured the following three

RADIUS server IP addresses in the switch:

5-47

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General