HP PROCURVE 2910AL User Manual

RADIUS Authentication and Accounting
Viewing RADIUS Statistics
Viewing RADIUS Statistics
General RADIUS Statistics
Syntax: show radius [host < ip-addr >]
Shows general RADIUS configuration, including the server
IP addresses. Optional form shows data for a specific
RADIUS host. To use show radius, the server’s IP address must
be configured in the switch, which. requires prior use of the
radius-server host command. (See “Configuring RADIUS
Accounting” on page 5-35.)
Figure 5-14. Example of General RADIUS Information from Show Radius Command
5-43

HP PROCURVE 2910AL Specifications

General

Model	HP ProCurve 2910al
Switching Capacity	128 Gbps
Throughput	95.2 Mpps
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
Manageable	Yes
Power	100-240 VAC
Power Supply	Internal
Operating Temperature	0°C to 45°C (32°F to 113°F)
Stacking	Yes
MAC Address Table Size	32000 entries
Routing Protocol	RIP, OSPF
Features	IPv6, VLAN, QoS, ACLs
Operating Humidity	15% to 95% non-condensing
Uplink Ports	4
Power over Ethernet	Yes (PoE+ models available)