To Next Page

To Previous Page

Configuring Port-Based and User-Based Access Control (802.1X)

Option For Authenticator Ports: Configure Port-Security To Allow Only 802.1X-Authenticated Devices

reauthenticate itself. If there are multiple clients authenticated on the

port, if one client loses access and attempts to re-authenticate, that client

will be handled as a new client on the port.

■ The first client to authenticate on a port configured to support multiple

clients will determine the port’s VLAN membership for any subsequent

clients that authenticate while an active session is already in effect.

Option For Authenticator Ports:

Configure Port-Security

To Allow Only 802.1X-Authenticated

Devices

If 802.1X authentication is disabled on a port or set to authorized (Force

Authorize), the port can allow access to a non-authenticated client. Port-

Security operates with 802.1X authentication only if the selected ports are

configured as 802.1X with the control mode in the port-access authenticator

command set to auto (the default setting). For example, if port A10 was at a

non-default 802.1X setting and you wanted to configure it to support the port-

security option, you would use the following aaa port-access command:

Control mode

required for Port-

Security Support

Figure 12-8. Port-Access Support for Port-Security Operation

12-47

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General