To Next Page

To Previous Page

RADIUS Authentication and Accounting

Configuring the Switch for RADIUS Authentication

Figure 5-4. Sample Configuration for RADIUS Server Before Changing the Key and

Adding Another Server

To make the changes listed prior to figure 5-4, you would do the following:

Changes the key

for the existing

server to

“source0127”

(step 1, above).

Adds the new

RADIUS server

with its required

“source0119” key.

Lists the switch’s

new RADIUS

server

configuration.

Compare this with

Figure 5-5. Sample Configuration for RADIUS Server After Changing the Key and Adding Another Server

To change the order in which the switch accesses RADIUS servers, refer to

“Changing RADIUS-Server Access Order” on page 5-47.

4. Configure the Switch’s Global RADIUS Parameters

You can configure the switch for the following global RADIUS parameters:

■ Number of login attempts: In a given session, specifies how many

tries at entering the correct username and password pair are allowed

before access is denied and the session terminated. (This is a general

aaa authentication parameter and is not specific to RADIUS.)

5-17

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General