To Next Page

To Previous Page

IPv4 Access Control Lists (ACLs)

Displaying ACL Configuration Data

Display an ACL Summary

This command lists the configured IPv4 ACLs.

Syntax: show access-list

List a summary table of the name, type, and application status

of IPv4 ACLs configured on the switch.

For example:

ProCurve(config)# show access-list

Access Control Lists

Type Appl Name

---- ----

std yes List-01-v4 IN

ext no List-02-v4 OUT

std yes 55

------------------------------------------

In this switch, the ACL named “List-02-v4-

OUT” exists in the configuration.

Figure 9-26. Example of show access-list Command

Figure 9-27. Example of a Summary Table of Access lists

Term Meaning

Type Shows whether the listed ACL is an IPv4

std AC or an IPv4 ext ACL.

Appl Shows whether the listed ACL has been applied to an interface (

yes/no).

Name Shows the identifier (name or number) assigned to each ACL configured in the switch.

9-86

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General