To Next Page

To Previous Page

Configuring Advanced Threat Protection

Using the Instrumentation Monitor

To enable instrumentation monitor using the default parameters and thresh-

olds, enter the general instrumentation monitor command. To adjust specific

settings, enter the name of the parameter that you wish to modify, and revise

the threshold limits as needed.

Examples

To turn on monitoring and event log messaging with the default medium

values:

ProCurve(config)# instrumentation monitor

To turn off monitoring of the system delay parameter:

ProCurve(config)# no instrumentation monitor system-

delay

To adjust the alert threshold for the MAC address count to the low value:

ProCurve(config)# instrumentation monitor mac-

address-count low

To adjust the alert threshold for the MAC address count to a specific value:

ProCurve(config)# instrumentation monitor mac-

address-count 767

To enable monitoring of learn discards with the default medium threshold

value:

ProCurve(config)# instrumentation monitor learn-

discards

To disable monitoring of learn discards:

ProCurve(config)# no instrumentation monitor learn-

discards

To enable or disable SNMP trap generation:

ProCurve(config)# [no] instrumentation monitor trap

10-26

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General