To Next Page

To Previous Page

RADIUS Authentication and Accounting

Using SNMP To View and Configure Switch Authentication Features

Changing and Viewing the SNMP Access Configuration

Syntax: snmp-server mib hpswitchauthmib < excluded | included >

included: Enables manager-level SNMP read/write access to the

switch’s authentication configuration (hpSwitchAuth) MIB.

excluded: Disables manager-level SNMP read/write access to the

switch’s authentication configuration (hpSwitchAuth) MIB.

(Default: included )

Syntax: show snmp-server

The output for this command has been enhanced to display the

current access status of the switch’s authentication configuration

MIB in the Excluded MIBs field.

For example, to disable SNMP access to the switch’s authentication MIB and

then display the result in the Excluded MIB field, you would execute the

following two commands.

ProCurve(config)# snmp-server mib hpswitchauthmib excluded

ProCurve(config)# show snmp-server

SNMP Communities

Community Name MIB View Write Access

---------------- -------- ------------

public Manager Unrestricted

Trap Receivers

Link-Change Traps Enabled on Ports [All] : All

Send Authentication Traps [No] : No

Address Community Events Sent in Trap

---------------------- ---------------- -------------------

Excluded MIBs

hpSwitchAuthenticationMIB

This command disables

SNMP security MIB

access.

Indicates that SNMP security MIB

access is disabled, which is the

nondefault setting.

Figure 5-8. Disabling SNMP Access to the Authentication MIB and Displaying the Result

5-22

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General