To Next Page

To Previous Page

RADIUS Authentication and Accounting

Using SNMP To View and Configure Switch Authentication Features

An alternate method of determining the current Authentication MIB access

state is to use the show run command.

ProCurve(config)# show run

Running configuration:

; J8715A Configuration Editor; Created on release #W.14.XX

hostname "ProCurve"

snmp-server mib hpSwitchAuthMIB excluded

ip default-gateway 10.10.24.55

snmp-server community "public" Operator

vlan 1

Indicates that SNMP access to the

authentication configuration MIB

(hpSwitchAuth) is disabled.

name "DEFAULT_VLAN"

untagged A1-A24,B1-B4

ip address 10.10.24.100 255.255.255.0

exit

password manager

Figure 5-9. Using the show run Command to View the Current Authentication MIB Access State

5-23

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General