To Next Page

To Previous Page

Configuring Secure Socket Layer (SSL)

Configuring the Switch for SSL Operation

Configuring the Switch for SSL

Operation

SSL-Related CLI Commands in This Section Page

web-management ssl page 8-19

show config page 8-19

show crypto host-cert 8-12

crypto key

generate cert [rsa] <512 | 768 |1024> 8-10

zeroize cert 8-10

crypto host-cert

generate self-signed [arg-list] 8-10

zeroize 8-10

1. Assigning a Local Login (Operator) and

Enabling (Manager) Password

At a minimum, ProCurve recommends that you always assign at least a

Manager password to the switch. Otherwise, under some circumstances,

anyone with Telnet, web, or serial port access could modify the switch’s

configuration.

Using the web browser interface To Configure Local Passwords. You

can configure both the Operator and Manager password on one screen. To

access the web browser interface, refer to the chapter titled “Using the

ProCurve Web Browser Interface” in the Management and Configuration

Guide for your switch.

8-7

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General